HFU HF Underground

Technical Topics => The RF Workbench => Topic started by: ChrisSmolinski on November 08, 2020, 1501 UTC

Title: Building your own RF spliters
Post by: ChrisSmolinski on November 08, 2020, 1501 UTC
Two of my recent RF projects, a 2-1 and a 3-1 splitter for HF and down. Wound on FT50-75 cores.

I use 1 pint "paint cans" for many of my RF projects, the lid provides a good surface for connectors and deadbug construction, testing is easy, then put it on the can for RF shielding when you're done.

First up, a 2-1 splitter based on this design, with a different resistor value: http://www.dxing.info/equipment/rolling_your_own_bryant.dx

(https://i.imgur.com/cJL1Eh5.png)

(https://i.imgur.com/IpejBKc.png)

Here's a nanoVNA plot of one of the outputs vs the input, mag(S21), the red line. Resistive load on the other output port. Not terrible, but not exactly close to what you'd expect, too much loss on the higher frequencies:

(https://i.imgur.com/qF6EFFF.png)




Next, a 3-1 splitter. This time, I just wound four identical windings, about a dozen turns each, no attempt to get fancy and match impedances or anything.

(https://i.imgur.com/nY3327r.png)

(https://i.imgur.com/E0UTWQB.png)

And the nanoVNA plot. Resistive loads on the other output ports. I think it's better  :)

(https://i.imgur.com/skOahqu.png)
Title: Re: Building your own RF spliters
Post by: RobRich on November 24, 2020, 0641 UTC
Like the project, and thanks for the VNA plots. 8)

Admittedly, recently I took the lazie... err, slacker approach to the issue for HF signal splitting to multiple receivers. I bought an used A/V distribution amp. Probably going to have to poke at it to better limit EMI/RFI and perhaps decrease the active gain a little, though. Maybe when I get around to hooking up the various receivers, which could be sometime between in a few minutes and possibly never. :slack:
Title: Re: Building your own RF spliters
Post by: syfr on December 08, 2020, 1603 UTC
I built the 4 port active splitter documented here

https://www.qsl.net/ko6bb/multicoupler_2.html

It works well, and the amp just makes up for the 3dB loss every time the signal is split (12dB total gain).

You can try it with :   mykiwisdr.hopto.org:8074

(https://i.imgur.com/nXMuHSS.jpg)