We seek to understand and document all radio transmissions, legal and otherwise, as part of the radio listening hobby. We do not encourage any radio operations contrary to regulations. Always consult with the appropriate authorities if you have questions concerning what is permissible in your locale.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - pulsartek

Pages: [1]
1
Equipment / Re: 22 Meter Band Part 15 CW Beacon Kits Now Available
« on: January 28, 2018, 1719 UTC »
Thanks, I just added it to Wiki.

2
Equipment / Re: 22 Meter Band Part 15 CW Beacon Kits Now Available
« on: January 28, 2018, 0433 UTC »
I built two of these kits. They work great. I enclosed some pictures. My situation required that I sit the transmitter on a high shelf in the closet of a spare room. A short coax connects the transmitter to a half wave dipole antenna in my attic. The cabinet is a CMC 11914, Jameco part #208901. The 'TEST/ CW' switch on the rear required a modification to the circuit board. In the 'off' (test) position, U1 output is not connected. This keys the transmitter steady for measurements and adjustments. In the 'on' (CW) position, U1 output is connected and the transmitter sends my ID in Morse code. This saves wear on the IC from pulling it in and out of the socket every time I need to check my output. Do this at your own risk. I cut out a piece of the trace between U1 socket pin 6 and R1. I connected one 24 Ga. solid wire to pin 6 of U1 socket and the other wire to the chip side of R1. With the output set to 480 millivolts for 4.6 milliwatts into my half wave dipole antenna, I have now heard my signal locally over 6 miles from my home at high locations. I purchased a 20 meter magnet mount antenna for my truck to use with my portable shortwave receiver. The antenna tuned to 13.56 MHz, so I can also use it to operate the beacon portable from mountain locations.

Pages: [1]