46
SDR - Software Defined Radio / Re: RX888 go on!
« on: October 12, 2020, 1942 UTC »
In a relatively cheap and basically homebrew unit the quality of work can vary a lot. However, RX888 seems to have a typical issue.
A Japanese blogger and Norwegian DXer have both complained that occasionally the noise level goes disastrously high. Then it is unexplicably over. I noticed the same issue, and it was easy to locate it to SMA antenna plug. When I opened the device I saw that the center pin of HF input was practically unsoldered. There was also something to say about two other pins.
I soldered the HF input again. After that there has been no problems.
Soon there will be a real field test and comparison with beverage antennas.
A Japanese blogger and Norwegian DXer have both complained that occasionally the noise level goes disastrously high. Then it is unexplicably over. I noticed the same issue, and it was easy to locate it to SMA antenna plug. When I opened the device I saw that the center pin of HF input was practically unsoldered. There was also something to say about two other pins.
I soldered the HF input again. After that there has been no problems.
Soon there will be a real field test and comparison with beverage antennas.