SDRuno 1.2 Release Notes (27th October 2017)
Summary: This release addresses a number of usability issues and bug fixes as well as implementing some new features.
The main change to the SP1 display has been to separate the resolution bandwidth (RBW) control from the zoom function. This gives the user the ability to trade off CPU load vs quality of the spectrum display. A number of defaults have also been changed to improve the quality of the main spectrum display.
Some other key changes are that the frequency entry can now be made in MHz as well as the default kHz entry.
Control + W now allows you to save the workspace to a specified slot.
Keypad buttons now not only take you to the specified band, but the sample rate and decimation are changed to enable band framing allowing you to see all of the band within the display.
Another new feature is the ability to store input RF power level and signal to noise ratio (SNR) for a given signal as defined by the displayed VFO in a CSV file. This file is updated at a rate you select in the SP1 settings panel so you can see how the power level and SNR change over time. Note that this is accurate to around 1dB and is a calibrated measurement to the input of the RSP.
Added:
IQ Wav file custom encoding
LO LOCK toggle hotkey - 'K'
Support for MHz frequency input using the M key
Support for MHz frequency input using the new . (DOT) and MHz keypad buttons
IF output frequency and enable state stored
Auto swap I/Q when in IF output mode
Facility to save Power and SNR measurements to a CSV file
Changing modes now changes the default step size
MCTR / TCTR / RSYN buttons state stored
Changed:
Keypad Ham band button functionality
Set and lock LO to centre of the band
Set SP1 display to show the entire selected band using appropriate sample rate and decimation factor
Ham band selection indicated by depressed keypad button
Default demodulation mode automatically selected for major Ham and broadcast bands
Zoom automatically zooms to the VFO
Workspaces now saved using CTRL+W
Default workspace opens windows to try to fill the screen
MA button default state is enabled
RBW slider used to define SP1 FFT size and display quality
Improved zoom functionality
Improved SP1 and SP2 settings defaults
Decimation filter improved for reduced spurious aliasing
Decimation values optimised for performance and usability
Default demodulation filter bandwidths selected to be appropriate for major Ham and broadcast bands
Fixed:
LSB/USB filter bandwidths all have same 100Hz offset from centre frequency
MA button now supports minimise/restore
Corrected error reporting
CAT control now supports ID; command
Improved the ADC Overload messaging functionality. Message colour now more suitable for colour blind people.
See the Downloads page (
http://www.sdrplay.com/downloads) for the link to the software and documentation.
Best regards,
SDRplay Software Development Team
Topic: SDRuno 1.2 Released (Read 2312 times)
