We seek to understand and document all radio transmissions, legal and otherwise, as part of the radio listening hobby. We do not encourage any radio operations contrary to regulations. Always consult with the appropriate authorities if you have questions concerning what is permissable in your locale.

Author Topic: Transmitter PCB's and Xtals  (Read 1721 times)

Offline Stretchyman

  • Hero Member
  • *****
  • Posts: 589
    • View Profile
Transmitter PCB's and Xtals
« on: January 21, 2018, 1511 UTC »
Selling a slightly older (pre GaN) PCB version of my PCB used for all my Tx's.

If you want to build your own (it uses commonly available parts) I can supply the PCB, Xtal (6930, pulls down to 6925) and toroids ALL for $50.

Full instructions provided!

FREE Postage ANYWHERE in the world.

If you can solder you can build it, it will allow SMT or thru' hole components to be fitted.

Have a few other components that I may throw in, just let me know what you need.

Uses an IRL510 as the O/P providing a 12-15W carrier at 12 -14V.

Stretchy.
'It's better to give than receive' so why RX when you can TX!

         15W and100W models available.

                   Buy one from me, NOW!


                                              ;)

Offline CharlieFoxtrot

  • Newbie
  • *
  • Posts: 7
    • View Profile
Re: Transmitter PCB's and Xtals
« Reply #1 on: April 27, 2018, 1203 UTC »
Hi there again. And what about this one? Is it recommended instead of LULU?

Offline Clutter Free

  • Newbie
  • *
  • Posts: 9
  • Ireland
    • View Profile
Re: Transmitter PCB's and Xtals
« Reply #2 on: April 27, 2018, 2333 UTC »
Hi there again. And what about this one? Is it recommended instead of LULU?

That one is LuLu :)

Offline Stretchyman

  • Hero Member
  • *****
  • Posts: 589
    • View Profile
Re: Transmitter PCB's and Xtals
« Reply #3 on: April 28, 2018, 0757 UTC »
Can (have) supply built boards so folk can experiment. Contact me via pm

Str.
'It's better to give than receive' so why RX when you can TX!

         15W and100W models available.

                   Buy one from me, NOW!


                                              ;)

Offline Stretchyman

  • Hero Member
  • *****
  • Posts: 589
    • View Profile
Re: Transmitter PCB's and Xtals
« Reply #4 on: May 01, 2018, 0819 UTC »
Have built up the last of my (none GaN) PCBs.

If you want to run from 12-14V and a 10-15W carrier, then these are perfect.

I've built up 13 PCBs with new components (no rubbish!), Tunes; 6925-6930KHz.

To keep them cheap I'm not going to do any coil winding, but all parts are supplied.

You'll just need to supply wire, tis all.

I've advertised them on Fleabay;
eBay item number:
132604604727

CONSIDERABLE DISCOUNT if ordered direct (via PM on HFU)

Str.
'It's better to give than receive' so why RX when you can TX!

         15W and100W models available.

                   Buy one from me, NOW!


                                              ;)