We seek to understand and document all radio transmissions, legal and otherwise, as part of the radio listening hobby. We do not encourage any radio operations contrary to regulations. Always consult with the appropriate authorities if you have questions concerning what is permissable in your locale.

Author Topic: Using a 20m Yagi for reception  (Read 161 times)

Offline IZS4

  • Hero Member
  • *****
  • Posts: 565
  • Florida
    • View Profile
Using a 20m Yagi for reception
« on: January 31, 2020, 0011 UTC »
I don't currently have a tribander in the air, but I was wondering if it's a common thing to use such antennas for reception being that its just under 14mhz (20m)
Listening on an Icom-718 with a 135' OCF dipole or a Grundig G3 and MLA-30 when portable. When QRP I use a Hendricks PFR-3 I built. Coverage is 20,30 and 40 meters.

Offline K3ZRT

  • Newbie
  • *
  • Posts: 7
    • View Profile
Re: Using a 20m Yagi for reception
« Reply #1 on: February 12, 2020, 0309 UTC »
I don't know that many do, but I don't see why it wouldn't suffice. A tuner would help a bit but it's close enough to work.

The great thing about reception is you don't risk blowing anything up, experiment! Try it out, if it works than yay, if not then back to the drawing board.

Offline Ed H

  • Jr. Member
  • **
  • Posts: 86
    • View Profile
Re: Using a 20m Yagi for reception
« Reply #2 on: February 24, 2020, 1125 UTC »
The most important thing I have found for receiving antennas and in particular for weak signal work is to guard against common mode noise. I am not sure how a Yagi will behave so far away from its design frequency, but would expect it to be rather inefficient, and with quite unknown directional response. However, if you can be sure that noise on the outside of the coax feeder doesn't add to the signals picked up by the elements (use of a good balun etc.) then the antenna could do well enough if also away from local noise. Since it is there, you might as well try it!

One of my receiving antennas is a "random wire dipole" made to fit the available space, with about 45 ft on each leg. At the centre connection to the coax I used a home made balun with separate primary and secondary windings, built on a binocular ferrite core. I think the transformer is an important part of the success of the system. Common mode noise on the coax is horrendous, but is completely absent in normal use and the system is great for 22m beacon reception. I have a long wire also connected in a similar manner, using an isolation transformer between aerial and earth points at the antenna, and the signal and shield of the coax. Similarly, this also does well in keeping the house noise out of the radios.

Cheers

Ed